# Mould in flow frames **URL:** \ **Category:** Flow Hive\ **Created:** [June 26, 2017, 10:11am UTC](https://forum.honeyflow.com/t/mould-in-flow-frames/11793 "2017-06-26T10:11:55Z")\ **Posts on this page:** 1\ **Showing post:** 20
**Author:** ![busso](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.honeyflow.com/busso/32/16301_2.png) [@busso](https://forum.honeyflow.com/u/busso)\ **Post date:** [August 21, 2017, 8:25am UTC](https://forum.honeyflow.com/t/mould-in-flow-frames/11793/20 "2017-08-21T08:25:44Z")
Up date on the Dishwasher. Let us just say I have gathered my jamas and some bedclothes, probably spending the night in the machinery shed. With the dishwasher set at 45 deg C (careful not to put the plastic above 70 deg) the water is not hot enough to melt the wax but the detergent tablet was able to remove/dissolve the wax and it all ended up as a gunky slurry in the bottom. Needless to say the filter and jets blocked and the dishwasher had a hissy fit and spat out lots of red lights. Wife was also flashing lots of red lights and noises which I desperately tried to avoid. I think she was angry.😡 Lots of hot water, a tooth brush and its all back going. Doing a clean run on hottest setting 75 Deg which should clean out any remaining wax. Hint to would be dishwasher’s: wait till Wife goes to town before running flow frames through the dishwasher. The flow frames seem perfectly OK. 😌 --- _[View the full topic](https://forum.honeyflow.com/t/mould-in-flow-frames/11793)._