# Wire alignment on flow frame **URL:** \ **Category:** Flow Hive\ **Created:** [October 11, 2016, 4:17pm UTC](https://forum.honeyflow.com/t/wire-alignment-on-flow-frame/8849 "2016-10-11T16:17:22Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![copashark](https://avatars.discourse-cdn.com/v4/letter/c/8e8cbc/32.png) [@copashark](https://forum.honeyflow.com/u/copashark)\ **Post date:** [October 11, 2016, 4:17pm UTC](https://forum.honeyflow.com/t/wire-alignment-on-flow-frame/8849/1 "2016-10-11T16:17:22Z")
Ive had my hive for a few months waiting for the spring. Now that my bees should be arriving Ive inspected my unused flow frame and notice that one wire is not aligned as the others are. I cannot budge the wire to match the other frames. Has anyone else experienced this? ![](https://us1.discourse-cdn.com/flex016/uploads/honeyflow/original/2X/9/9f5f021111ed1337e4fe1a6b0a9d34b6412169a9.jpg) ---
**Author:** ![Michael\_Bush](https://sea2.discourse-cdn.com/flex016/user_avatar/forum.honeyflow.com/michael_bush/32/1024_2.png) [@Michael\_Bush](https://forum.honeyflow.com/u/Michael_Bush)\ **Post date:** [October 11, 2016, 8:04pm UTC](https://forum.honeyflow.com/t/wire-alignment-on-flow-frame/8849/2 "2016-10-11T20:04:40Z")
If the wire is tight, it’s good. It doesn’t have to line up with anything on some other frame… ---
**Author:** ![onehivehoney](https://avatars.discourse-cdn.com/v4/letter/o/d07c76/32.png) [@onehivehoney](https://forum.honeyflow.com/u/onehivehoney)\ **Post date:** [October 12, 2016, 1:34am UTC](https://forum.honeyflow.com/t/wire-alignment-on-flow-frame/8849/3 "2016-10-12T01:34:37Z")
I’ve had my wires fall off and had to reassemble the thing. If you go to the other end end and move it round you’ll get a little extra slack. That’ll allow the wire to fall into the groove, where it belongs. If its not in that groove it’ll slip off. Use a stick or a piece of plastic to help push it in